This process does not cause special difficulties. It is necessary to comply with the rules in preparing the basis.
Under the floor covering, the base should be solid, dry and even. All irregularities should not exceed more than seven millimeters. On the basis of the capillary moisture should not be. On the floors this usually does not happen. If on the basis of a moisture content of more than three percent the carpet cannot be laid. Before laying the coating, a self -leveling mixture is applied to the concrete floor. Wooden floor covering chipboard. Now is the time to set wooden euro -windows whose price is inexpensive. There should be no hats, nails and protruding elements on the coating. All joints are thoroughly putty. Then a special primer is applied to the coating. The temperature in the room during gluing should be not lower than seventeen degrees. The material is glued to a special glue. In the room where the carpet will be laid, it is aligned under the influence of cargo.
The material is better to lay a whole sheet. If the joint is assumed, its presence should be parallel to the light. The material is cut out with a sharp tool after bending on the wall. Then the coating is evenly glued. For thorough gluing without air pillows, roll a roller on the material. The room is tightly closed during operation. After the styling is finished and the coating dried up the room carefully ventilated until the specific smell disappears. Carpet can be glued to a double -sided tape.